Innokin's Sceptre kit is a very design pod mod, easy to use and above all terribly efficient !
Its dimensions (106.8 x 29 x 18mm) are very ergonomic.
Its rubber coating makes it particularly pleasant to the touch. The upper part is metallic, some of the colours have a beautiful honeycomb coating. On the side of the mod is the Fire button. It can be activated and deactivated with 3 clicks.
It’s equipped with all the safety features one would expect from such a device : against overheating, short circuit and excessive discharge, as well as protection during charging.
Its cartridges offer a capacity of 3ml. They are easily filled from the side by removing the rubber tab. The coils can be changed in a jiffy. Simply remove the cartridge from the mod, rotate the lower part according to the instructions, unscrew the coil, place a new one and put it back together !
Two types of coils are available :
- A 0.5ohm for a restrictive aerial draw (RDL)
- A 1.2ohm for tight draw (MTL) and/or high nicotine levels
The mod automatically detects the value of the installed coil and adapts the power accordingly.
Two settings are available with each coil. To change it, hold down the Fire button for 3 seconds when the mod is off. You’ll then see a light. The green one indicates that you’re on the lowest power (18W with the 0.5ohm and 9W with the 1.2ohm) and the purple one, the highest power (20W with the 0.5 and 10W with the 1.2ohm).
In addition to these settings, the cartridges are equipped with an adjustable airflow with MTL and RDL markings on the sides to indicate what type of draw you’re in. It allows you to adjust the airflow to your preferences.
The mod is equipped with a 1400mAh battery, which gives it great autonomy !
And a led indicates the remaining battery level (green = 100-50%, blue = 50-10% and red = 10-0%).